SMR Gearbox Set up
Satisfactory performance depends upon suitable installation. lubrication and maintenance. for that reason it is necessary that the directions in the set up and upkeep leaflet. provided with every single gearbox. are followed cautiously. several of the essential aspects of 
belt and torque-arm installation are listed beneath.
1. Install pulley on gearbox input shaft as near towards the reducer attainable, and mount reducer on driven shaft as near to bearing as useful. failure to accomplish this will likely bring about extra loads during the input shaft bearings and output bearings and could trigger their premature failure.
2. Install motor and wedge belt drive together with the belt pull at about 90° to your center line in between driven and input shafts. this will allow tensioning with the wedge belt drive using the torque arm which really should ideally be in tension. if output hub runs anti-clockwise. torque arm need to be positioned the correct.
three. lnstall torque-arm fulcrum on the rigid assistance in order that the torque-arm will be at roughly proper angles to your center line through the driven shaft and also the torque arm situation bolt. be sure there exists enough get up within the turnbuckle for belt tension adjustment.
Retain near.
Bell drive could possibly be found in any hassle-free postion. in case the torque arm will be to be applied to tighten the belts, the drive needs to be at about tight angle on the line in between the input and output shafts.
Bell drive might be positioned to your right if wanted.
If output hub rotates clock-wise. position belt drive and torque arm in opposite route to that shown inside the illustration.
Torque arm and belt get up.
Torque arm could be mounted on the appropriate if sought after.
