Power UNITS FOR LIFT TABLE one
General Description
This energy unit is developed exclusively for that modest lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has been extensively used within the industry of logistic gadgets including minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is controlled by the solenoid valve using the pace managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Common Description
This power unit is designed solely for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve as well as the pace controlled from the adjustable needle valve. When the lift rises to a large positoin, however the electrical power provide is cut, the reducing movement is controlled through the guide override function.
Electrical power UNITS FOR LIFT TABLE three
General Description
This power unit is made solely to the huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve as well as the velocity managed by a stress compensated flow handle valve.
Electrical power UNITS FOR LIFT TABLE four
General Description
This power unit is created solely for your big lift table, Consisting 
of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve as well as the speed controlled through the adjustable needle valve. Once the lift rises to a higher positoin, but the power provide is reduce, the reducing motion is controlled through the manual override function.
Special Notes
1. This electrical power unit is of S3 duty cycle, which could only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean every one of the hydraulic components concerned before installation of the power unit.
three. Viscosity with the oil shoud be 15~46 cst,which need to also be clean and free of charge of impurities.N46 hydraulic oil is recommended.
4. Oil modifying is needed after the preliminary 100 operation hrs,afterwards as soon as every single 3000 hrs.
5. The energy unit proven is designed to be mounted vertically.
